updateThe instructions detailed below are the same for the following 3D Printers: CR10, Tevo Tornado. If you have a 3D Printer on which this suction head fits, please tell us and we will add it to our compatibility list.
Step 1. Print the adapters
For the CR 10, you will need to print these parts, already oriented as needed. Here are a few recommendations for printing:
In order to make a perfect setup for hoovering a maximum of nanoparticles and COVs, we choose to remove the original steel extruder cover (See picture below). The blower air guide we’ve redesigned will also improve the filament cooling a lot.
Step 3. Installing the 3 new 3D printed parts
As you can see on the rendering below, we’ve designed 3 new parts you need to 3D print. One suction head where you plug Zimpure’s hose in, one air guide for the filament blower, and one air guide for the heat sink cooling fan.
Step 4. Operating instruction (IMPORTANT)
Here you go, your Zimpure is ready to filter!
You need to turn it ON only after than your CR 10 has started to print.
Please verify how the beginning of the first layer goes.
You are now all set up to print safely, without any toxic emissions. You can see how Zimpure is efficient by smelling on the top of your CR 10. No more bad and hazardous ABS smelt!