FlashForge Creator Pro instructions build

  • Step 1. Print the adapters
    For the FlashForge Creator Pro, you will need to print 2 little parts. All these parts are already oriented as needed. Here are a few recommendations for printing:

    File Material Layer Height Supports Infill Download
    FlashForgeSuctionHead.STL ABS 0.1 NO HIGH file_download

    Creative Commons License
    This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

    This little print is your last one without Zimpure! :)
  • Step 2. Installing the FlashForge Suction Head
    Unscrew the two screws of the plastic part which holds the filament guide and remove it. Place the FlashForge Suction Head at this place as shown on the picture below. Rescrew these two screws.

  • Step 3. Installing the Hose
    Insert the hose into the Creator Pro Suction Head and plug the other side of the hose into Zimpure.

  • Step 4. Operating instruction (IMPORTANT)
    Here you go, your Zimpure is ready to filter!

    You need to turn it ON only after than your Creator Pro has started to print.

    Please verify how the beginning of the first layer goes. You are now all set up to print safely, without any toxic emissions. You can see how Zimpure is efficient by smelling on the top of your Creator Pro. No more bad and hazardous ABS smelt!

    Happy safe printing!

Any idea/suggestion? Something is not clear? Please send us an email!