Raise 3D N Series instructions build

  • Step 1. Print the adapters
    For the Raise 3D, you will need to print 2 little parts. The suction head needs supports to be well printed, but not inside. That's why we've made a STL with supports, so you can print it without worrying about the supports. All these parts are already oriented as needed. Here are a few recommendations for printing:

    File Material Layer Height Supports Infill Download
    UpperHoseHolder ABS 0.2 NO MEDIUM file_download
    RaiseSuctionHead ABS 0.1 YES MEDIUM file_download
    RaiseSuctionHeadWithSupports ABS 0.1 NO MEDIUM file_download
    Cover90Adaptor ABS 0.1 NO MEDIUM file_download

    Creative Commons License
    This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

    These prints are your last ones without Zimpure!
  • Step 2. Installing the RaiseSuctionHead
    Unscrew the right extruder fan of your Raise 3D. Remove the original filament cooling adapter, and replace it by the RaiseSuctionHead.

  • Step 3. Tighten the Hose Holder
    Use one back to back Velcro tape to tighten the UpperHoseHolder.

  • Step 4. Installing the Hose
    Insert the hose into the UpperHoseHolder and in the RaiseSuctionHead.

  • Step 5. Operating instruction (IMPORTANT)
    Plug the hose to Zimpure and here you go, your Zimpure is ready to filter!
    If you use the RAISE Cover, leave Zimpure into the chamber as shown on the picutre, but use the Cover90Adaptor so the hose will not bend.

    You need to turn it ON only after than your Raise 3D has started to print.

    Please verify how the beginning of the first layer goes.
    You are now all set up to print safely, without any toxic emissions. You can see how Zimpure is efficient by smelling on the top of your Raise. No more bad and hazardous ABS smelt!

    Happy safe printing!

Any idea/suggestion? Something is not clear? Please send us an email!