Ultimaker 2+ instructions build

  • Step 1. Print the adapters
    For the Ultimaker 2+, you will need to print two parts, already oriented as needed. Here are a few recommendations for printing:

    File Material Layer Height Supports Infill Download
    Holder.stl ABS 0.09 YES HIGH file_download
    Tube.stl ABS 0.09 YES HIGH file_download

    Creative Commons License
    This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.

    This print is your last one without Zimpure!

    Thanks to Oscar Galego from bikespot for this nice design!
  • Step 2. Installing the Ultimaker 2+ Suction Head
    Mount the tube as shown on the picture below.

    Then, mount the holder.

  • Step 3. Installing the Hose
    Insert the hose into the Ultimaker 2+ holder and plug the other side of the hose into Zimpure.

  • Step 4. Operating instruction (IMPORTANT)
    Here you go, your Zimpure is ready to filter!

    You need to turn it ON only after than your Ultimaker 2+ has started to print.

    Please verify how the beginning of the first layer goes. You are now all set up to print safely, without any toxic emissions. You can see how Zimpure is efficient by smelling on the top of your Ultimaker 2+. No more bad and hazardous ABS smelt!

    Happy safe printing!

Any idea/suggestion? Something is not clear? Please send us an email!