update Updated: 11/15/2018

Zimpure - Ultimaker Original+ instructions build


supervisor_account To speak with the Zimple community about this printer, suction head compatibility or improvements, you can join the Discord channel for this printer.



update You'll find below the instructions for the Ultimaker 2+. This is the same suction head for your Ultimaker Original+. In case of problem, contact us at nicolas@zimple3d.com. If your suction head is installed, please send us some photos!



  • Step 1. Print the adapters


    For the Ultimaker Original+, you will need to print these files, already oriented as needed. Here are a few recommendations for printing: 

    File Material Layer Height Supports Infill Download
    STLHolder.stl Flexible 0.1 YES HIGH
    file_download
    STLTube.stl Flexible 0.1 YES HIGH
    file_download

    Creative Commons License
    This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.


    This print is your last one without Zimpure! 

    Thanks to Oscar Galego from bikespot for this nice design!

  • Step 2. Installing the Ultimaker Original+ Suction Head

    First, install the Ultimaker Original+ suction head that you downloaded above on your extruder.

    Original+/imgStep/Original+/instructions1.JPG
    Original+/imgStep/Original+/instructions2.JPG
  • Step 3.Installing the Hose

    Insert the hose into the Original+ holder and plug the other side of the hose into Zimpure.

    Original+/imgStep/Original+/instructions3.JPG
  • Step 4. Operating Instruction

    Here you go, your Zimpure is ready to filter! You need to turn it ON only after than your Original+ has started to print. Please verify how the beginning of the first layer goes. You are now all set up to print safely, without any toxic emissions. Happy safe printing!