update Updated: 11/15/2018

Zimpure - Wanhao duplicator6 instructions build


supervisor_account To speak with the Zimple community about this printer, suction head compatibility or improvements, you can join the Discord channel for this printer.






  • Step 1. Print the adapters


    For the Wanhao duplicator6, you will need to print these files, already oriented as needed. Here are a few recommendations for printing: 

    File Material Layer Height Supports Infill Download
    STLM200ZortraxSuctionHead.STL ABS/ULTRA 0.09 NO HIGH
    file_download
    STLM200CLIP-P1-Hose-Holder.STL ABS/ULTRA 0.19 NO HIGH
    file_download
    STLM200CLIP-P2-Hose-Holder.STL ABS/ULTRA 0.19 YES HIGH
    file_download
    STLM200ExtruderCableSupport.STL ABS/ULTRA 0.19 NO HIGH
    file_download

    Creative Commons License
    This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.


    This is your last print without Zimpure!

  • Step 2.Installing the Zortrax Hose Holder

    Mount the CLIP-P1-Hose-Holder into the CLIP-P2-Hose-Holder. Then, unplug the original CLIP-P2-Hose-Holder and clip your new one.

    duplicator6/imgStep/M200/instructions1.JPG
    duplicator6/imgStep/M200/instructions2.JPG
  • Step 3.Installing the Zortrax suction head

    Insert the back to back Velcro tape into the ZortraxSuctionHead. Then, place the adapter on the bottom side of your extruder as shown on the picture below. Tighten the back to back Velcro tape as shown on the second picture below.

    duplicator6/imgStep/M200/instructions4.JPG
    duplicator6/imgStep/M200/instructions5.JPG
  • Step 4.Installing the Hose

    Insert the hose into CLIP-P2-Hose-Holder, and push to the Zortrax suction head. Hold the sunction head while inserting the hose into it. Clip the hose in the HoseHolderChassis. Push the CableExtruderSupport to prevent damaging the extruder connection. Then, insert the Hose into your Zimpure.

    duplicator6/imgStep/M200/instructions5_xxzWudr.JPG
    duplicator6/imgStep/M200/instructions6.JPG
    duplicator6/imgStep/M200/instructions7.JPG
    duplicator6/imgStep/M200/instructions8.JPG
  • Step 5.Operating instruction (IMPORTANT)

    Here you go, your Zimpure is ready to filter! You need to turn it ON only after than your Zortrax has started to print. Please verify how the beginning of the first layer goes. You are now all set up to print safely, without any toxic emissions. You can see how Zimpure is efficient by smelling on the top of Zortrax. No more bad and hazardous ABS smelt! Happy safe printing!